Cadet 8F2500-8 Dokumentacja Pobierz pdf

240 VOLT MODELS

2F350 6F1500

2F500 8F2000

3F750 8F2500

4F1000 10F2500

5F1250

208 VOLT MODELS

2F500-8 3F750-8 4F1000-8

5F1250-8 6F1500-8 8F2000-8

8F2500-8

120 VOLT MODELS

2F500-1 3F750-1 4F1000-1

6F1500-1

The Cadet

Electric Baseboard

OWNER’S GUIDE

IMPORTANT INSTRUCTIONS

SAVE THESE INSTRUCTIONS

WARNING!

Turn the electrical power off at the electrical

panel board (circuit breaker or fuse box) and

lock or tag the panel board door to prevent

someone from turning on power while you are

working on the heater. Failure to do so could

result in serious electrical shock, burns, or

possible death.

1. Read all instructions before using this heater.

2. Read all information labels. Verify that the electrical supply

wires are the same voltage as the heater.

3. All electrical work and materials must comply with the

National Electric Code (NEC), the Occupational Safety and

Health Act (OSHA), and all state and local codes.

4. The heater must be grounded to the grounding pigtail (copper

wire) provided.

5. If you need to install a new circuit or need additional wiring

information, consult a qualified electrician.

6. Protect electrical supply from kinks, sharp objects, oil, grease,

hot surfaces or chemicals.

7. Do not place heater against paperboard or low-density

cellulose fiberboard surfaces.

8. Do not place heater below an electrical convenience receptacle.

9. WARNING

Overheating or fire may occur. Do not install the heater behind doors.

10. WARNING

Fire or explosion may occur. Heater has hot and arcing or sparking

parts inside. Do not install heater in any area where combustible

vapors, gases, liquids, or excessive lint or dust are present.

11. WARNING

Burn Hazard. This heater is hot when in use. To avoid burns, do

not let bare skin touch hot surfaces. Use extreme caution when

any heater is used by or near children or invalids and whenever

the heater is left operating unattended.

12. WARNING

Risk of electrical shock. Keep all foreign objects out of heater.

Do not operate after heater malfunctions or has been dropped

or damaged in any manner.

13. WARNING

Risk of Fire. Do not block heater. Heater must be kept clear of

all obstructions: minimum of 12 inches in front and above,

6 inches on both sides. Heaters must be kept clean of excessive

lint, dirt and debris. (See Maintenance Instructions)

14.Use this heater only as described in this manual. Any other use

not recommended by the manufacturer may cause fire, electrical

shock, or injury to persons.

Features & Benefits

•

Oversized high temperature limit switch with full

length sensor for added safety

•

Durable steel sheathed element with a limited

lifetime warranty

•

Easy installation with pre-punched case at 1” intervals

•

Rugged steel construction

•

Thermostat not included

Tel: 360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675

TOOLS REQUIRED

•

Phillips

Screwdriver

•

Straight

Screwdriver

•

Wire Strippers

•

Drill or Hammer

•

Drill Bits

•

(4) Wood Screws

•

(3) Wire Nuts

•

(1) Strain Relief

Connector

1 2 3 4 5 6 7 8

Podsumowanie treści

Strona 1 - Electric Baseboard

240 VOLT MODELS2F350 6F15002F500 8F20003F750 8F25004F1000 10F25005F1250208 VOLT MODELS2F500-8 3F750-8 4F1000-85F1250-8 6F1500-8 8F2000-88F2500-8120 VO

Strona 2 - Installation Instructions

Baseboard WiringIMPORTANT! It is important that you verify theelectrical supply wires are the same voltage asthe heater. Check heater specifications t

Strona 3 - Operation & Maintenance

Installation InstructionsLOWOFFFigure 4Left SideWiring ShownFigure 5Left SideWiring ShownBASEBOARD WIRING WITH A SINGLE POLE (2 WIRE)WALL THERMOSTAT -

Strona 4 - WARRANTY

* Black soot and residue is formed by the combustion of hydrocarbons. Existing hydrocarbons in environment pass through heater element and scorch,exit

Strona 5 - GUÍA PARA EL PROPIETARIO

MODELOS DE 240 VOLTIOS2F350 6F15002F500 8F20003F750 8F25004F1000 10F25005F1250MODELOS DE 208 VOLTIOS2F500-8 3F750-8 4F1000-85F1250-8 6F1500-8 8F2000-8

Strona 6 - Área de Instalación

Cableado del Zócalo¡IMPORTANTE! Es importante verificar que todos losalambres eléctricos sean del mismo voltaje que elcalentador. Revise las especific

Strona 7 - Mantenimiento

Instrucciones Para la InstalaciónLOWOFFFigura 4Aparece el cableadodel lado izquierdoFigura 5Aparece el cableadodel lado izquierdoCABLEADO DEL ZÓCALO C

Strona 8 - GARANTÍA

* El hollín y los residuos se forman por la combustión de los hidrocarburos. Los hidrocarburos existentes en el entorno pasan por el elemento calentad