Cadet 8F2000-8 Dokumentacja

Przeglądaj online lub pobierz Dokumentacja dla Grzejniki Cadet 8F2000-8. Cadet 8F2000-8 Specifications Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 12
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
240/208 VOLT MODELS
2F350 6F1500
2F500 8F2000
3F750 8F2500
4F1000 8F2025
5F1250 10F2500
208 VOLT MODELS
2F500-8 3F750-8 4F1000-8
5F1250-8 6F1500-8 8F2000-8
8F2500-8
120 VOLT MODELS
2F500-1 3F750-1 4F1000-1
6F1500-1
The Cadet
Electric Baseboard
OWNER’S
GUIDE
IMPORTANT INSTRUCTIONS
SAVE
THESE
INSTRUCTIONS
WARNING!
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and
lock or tag the panel board door to prevent
someone from turning on power while you are
working on the heater. Failure to do so could
result in serious electrical shock, burns, or
possible death.
CAUTION - High Temperature. Keep electrical cords, drapes,
and other furnishings away from heater.
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock,
and injury to persons, including the following:
1. Read all instructions before using this heater.
2. Read all information labels. Verify that the electrical supply
wires are the same voltage as the heater.
3. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.
4. The heater must be grounded to one of the grounding screws
provided.
5. If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil,
grease, hot surfaces or chemicals.
7. Do not place heater against paperboard or low-density
cellulose fiberboard surfaces.
8. Do not place heater below an electrical convenience receptacle.
9. WARNING
Overheating or fire may occur. Do not install the heater
behind doors.
10. WARNING
Fire or explosion may occur. Heater has hot and arcing or
sparking parts inside. Do not install heater in any area where
combustible vapors, gases, liquids, or excessive lint or dust
are present.
11. WARNING
Burn Hazard. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. Use extreme caution
when any heater is used by or near children or invalids and
whenever the heater is left operating unattended. Keep
combustible materials, such as furniture, pillows, bedding,
papers, clothes, and curtains away from heater.
12. WARNING
Risk of electrical shock. Do not insert or allow foreign
objects to enter any ventilation or exhaust opening as this
may cause an electric shock or fire, or damage the heater.
13. WARNING
Risk of Fire. Do not block heater. To prevent a possible fire, do
not block air intakes or exhaust in any manner. Heater must
be kept clear of all obstructions: minimum of 12 inches in front
and above, 6 inches on both sides. Heater must be kept clean
of excessive lint, dirt and debris (See Maintenance Instructions).
14.Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electrical shock, or injury to persons.
Features & Benefits
Oversized high temperature limit switch with full
length sensor for added safety
Durable steel sheathed element with a limited
lifetime warranty
Easy installation with pre-punched case at 1” intervals
Rugged steel construction
Thermostat not included
www.cadetco.com
Tel:
360-693-2505
P.O.
Box
1675
Vancouver,
WA
98668-1675
TOOLS REQUIRED
Phillips
Screwdriver
Straight
Screwdriver
Wire Strippers
Drill or Hammer
Drill Bits
(4) Wood Screws
Wire Connectors
(1) Strain Relief
Connector
1
Przeglądanie stron 0
1 2 3 4 5 6 ... 11 12

Podsumowanie treści

Strona 1 - Electric Baseboard

240/208 VOLT MODELS2F350 6F15002F500 8F20003F750 8F25004F1000 8F20255F1250 10F2500208 VOLT MODELS2F500-8 3F750-8 4F1000-85F1250-8 6F1500-8 8F2000-88F2

Strona 2 - Installation Instructions

Figura 9Aparece elcableado dellado izquierdoFigura 8Aparece el cableadodel lado derechoZÓCALOS ESTÁNDAR: CABLEADO EN EL LADO DERECHO SUMINISTRO DE 12

Strona 3

BACABLEADO DE MÚLTIPLES ZÓCALOS. SUMINISTRO DE 240V SOLAMENTE (Consulte la figura 14)1. Cableado del lado izquierdo: desempalme el conector de fábrica

Strona 4

* El hollín y los residuos se forman por la combustión de los hidrocarburos. Los hidrocarburos existentes en el entorno pasan por el elemento calentad

Strona 5 - DOUBLE POLE WALL THERMOSTAT

THERMOSTATA thermostat is required. A Cadet wall thermostat is recommendedfor optimum performance, or you may prefer the convenience of abuilt-in ther

Strona 6 - Operation & Maintenance

NOTE: You do not need to disassemble any additional parts to mountthe heater.6. Connect the grounding lead to the grounding screw (See Figure 4).Both

Strona 7 - CONSERVE ESTAS INSTRUCCIÓNES

Figure 9Left Side Wiring ShownFigure 8Right Side Wiring ShownSTANDARD BASEBOARD WIRING ON RIGHT SIDE 120V OR 240V SUPPLY (See Figure 8)1. Connect one

Strona 8 - Espaciado mínimo de 12”

BAMULTIPLE BASEBOARD WIRING. 240V SUPPLY ONLY (See Figure 14)1. Left side wiring: disconnect factory connector A. Right side wiring: disconnect factor

Strona 9 - PASO 2: Cableado del zócalo

* Black soot and residue is formed by the combustion of hydrocarbons. Existing hydrocarbons in environment pass through heater element and scorch, exi

Strona 10 - Alambre rojo

MODELOS DE 240/208 VOLTIOS2F350 6F15002F500 8F20003F750 8F25004F1000 8F20255F1250 10F2500MODELOS DE 208 VOLTIOS2F500-8 3F750-8 4F1000-85F1250-8 6F1500

Strona 11 - ESTÁNDAR

TERMOSTATOSe requiere un termostato. Se recomienda un termostato mural Cadetpara un óptimo rendimiento, o bien puede optar por la comodidadde un juego

Strona 12 - GARANTÍA

NOTA: No es necesario desarmar ninguna pieza adicional para montarel calentador.Instrucciones Para La InstalaciónTAPA DEL COMPARTIMIENTO DE CABLEADOMO

Komentarze do niniejszej Instrukcji

Brak uwag